Terraco Pluggit 311

Terraco Pluggit 311, available from Al Tashteb Al Saree in Bu-Tina, Sharjah. Ask for price and stock on WhatsApp or call us.

WhatsApp usCall now

SKU: ATS-TER-B005568 Category:
Request a quote
Please enable JavaScript in your browser to complete this form.
Tell us the quantity needed, or the area to be covered.
Brand, size, colour or other details that help us prepare your quote.

Terraco Pluggit 311 is Terraco’s rapid-setting, cement-based water-stop mortar (product code 76311) for plugging active leaks and running water in concrete and masonry. Al Tashteb Al Saree is an authorised Terraco distributor, supplying Pluggit 311 from our shop in Bu-Tina, Sharjah, to Dubai, Sharjah, Ajman and the rest of the UAE.

Ask for price and stock on WhatsApp or call +971 52 510 4678.

What is Pluggit 311?

Pluggit 311 is a one-component, dark grey cementitious powder that sets in about 5 minutes, fast enough to stop water that is actively running or seeping through a crack, hole or joint. It is shrinkage-compensated, chloride-free and sets above or below water, so it can be pressed straight into a leaking basement wall, tank or pipe penetration. Once the leak is stopped, the area can be waterproofed or overcoated.

Typical UAE uses are leaks in basement walls and lift pits where the water table is high, water tank and reservoir repairs, leaking pipe and conduit entries, and sealing static cracks and holes in foundations before applying a waterproofing coating.

Where to use it

  • Stopping running water or seepage through concrete or masonry
  • Filling static cracks and holes in foundations, basements, tunnels and reservoirs
  • Water tanks and sewer pipes
  • Sealing around pipe penetrations before waterproofing

Technical data

TypeOne-component, rapid-setting cementitious water-stop mortar
Product code76311
ColourDark grey
Mixing water0.26 L per 1 kg of powder (stiff paste)
Yield13.5 L of mix per 20 kg with 5.2 L water
Initial setAbout 5 minutes
Final setAbout 2 hours (depends on temperature)
Compressive strength> 20 N/mm² at 7 days; > 25 N/mm² at 28 days
Flexural strength> 3 N/mm² at 7 days; > 8 N/mm² at 28 days
Tensile strength> 1 N/mm² at 28 days
Consumption1.6 kg/m² per mm
Maximum thickness50 mm vertical; 30 mm overhead
Wet density1,900 kg/m³
Application temperature+5 °C to +30 °C
Packaging (data sheet)5 kg pail (5 × 1 kg) or 20 kg pail (20 × 1 kg)
Shelf life9 months unopened

How to apply

  1. Remove dust, dirt, debris, salts, oil and grease. Protect adjacent surfaces.
  2. Cut out the crack or hole so the plug can key in, and remove standing water. If the area is dry, dampen it first.
  3. Mix only what you can use in 1–2 minutes: about 0.26 L of water per 1 kg, to a stiff paste. Never mix for more than 30 seconds.
  4. Press the paste firmly into the void and hold it in place until it sets, usually 3–5 minutes.
  5. Once set, trim the excess flush with a trowel or spatula.
  6. Overcoat with Terraco Weathercoat if required after initial set, and clean tools with water straight away.

How much do you need?

The pails contain individual 1 kg packs, so you can open one at a time. One kilo makes about 0.68 litres of mix (Terraco’s 13.5 L per 20 kg).

RepairApprox. volumePluggit needed
Hole 50 × 50 × 50 mm0.125 Labout 0.2 kg
Crack chased 20 × 20 mm, 1 m long0.4 Labout 0.6 kg
Pipe entry ring, 100 mm pipe, 25 mm gap, 50 mm deepabout 0.5 Labout 0.7 kg

Volumes are our calculations from Terraco’s yield figure; allow extra for waste, because the mix sets very quickly.

Safety

  • Wear gloves and goggles: it is cement-based and sets fast.
  • Store dry, away from direct sun and extreme heat or cold. Shelf life is 9 months unopened.

Frequently asked questions

Will it really set under running water?

Yes. Terraco lists setting above and below water. Press and hold it in the leak until it sets, usually 3–5 minutes.

Is Pluggit a waterproofing coating?

No. It plugs leaks, cracks and holes. Waterproof the area afterwards with a suitable coating.

Why mix so little at a time?

It starts setting in about 5 minutes, so mix only what you can place in 1–2 minutes.

Data sheet and related products

Technical data from the Terraco data sheet for Pluggit 311. Always check the latest data sheet before specifying.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Shopping Cart
Scroll to Top